Door Controller/Commands
Contents |
Supported Commands
All commands must be followed by carriage return (\r) unless otherwise indicated.
?
- Syntax
- ?
- Example
- ?
- Returns
- <About information>
Returns the ‘About’ information for this door controller
<ENTER>
- Syntax
- \r
- Example
- \r
- Returns
- OK:null:
Simple keepalive
U
- Syntax
- U[<time>]
- Example
- U3
- Returns
- OK:unlock:<time>
Unlocks the door for the specified number of seconds. If no time is specified, uses the default unlocktime stored in internal configuration
uptime
- Syntax
- uptime
- Example
- uptime
- Returns
- INFO:uptime:<millis>
Returns the length of time since the last board restart, in milliseconds
debug
- Syntax
- debug [<level> | cmd | keypad | ibutton | wiegand | eeprom | local]
- Example
- debug
- Returns
- INFO:debug:<level>
- Example
- debug 4
- Returns
- OK:debug:<level>
Shows the current debugging level, or sets a new one. If a value is specified, this overwrites the previous bitmask; otherwise debugging for the specified parameter is added to the existing bitmask.
test
- Syntax
- test [input | output]
- Example
- test input
- Returns
- <live test output>
This command is not suitable for automated use. It will exercise all inputs or outputs, and show the results continually until a further key is pressed.
free
- Syntax
- free
- Example
- free
- Returns
- INFO:free:<bytes>
Returns the amount of available internal RAM, in bytes
set
- Syntax
- set [name | num | local<num> | unlocktime | lockinvert | mac <value>]
- Example
- set local0 WG:123456
- Returns
- <all values> (if no parameters given)
- <nothing> (if a new value is set)
Displays all current EEPROM settings, or changes a single setting.
