Door Controller/Construction details

Construction details

• Serial version: TX-TX, RX-RX from RS232 driver to Arduino
• Ethernet version: TX-RX, RX-TX from Ethernet driver to Arduino
• Suggested wiring order
  • 1 F-F 5V PSU -> Ethernet
  • 5 M-F vIn/GND/Reader/Voltage_Divider -> Arduino
  • 3 M-F Arduino TX/RX, GND-> Ethernet
  • 1 M-F Arduino CFG -> Ethernet
  • 4 F-F Relay -> Arduino

Connection board

• Brown/Blue cable length: cut to 75mm

Bi-colour LED

• Black/Red/Green cable length: cut to 30cm
• For LED SC07647
  • Resistor value 120R
  • Pin by flat edge: Red
  • Centre pin: Ground
  • Pin opposite flat edge: Green