Door Controller/Revision History
From ESCTL
< Door Controller(Difference between revisions)
(→Software) |
|||
| Line 2: | Line 2: | ||
The following tables show key revisions and the changes each introduced. | The following tables show key revisions and the changes each introduced. | ||
| + | |||
| + | Development has migrated from SVN to git. For earlier changes, the SVN revision number is given; for later changes only the git commit ID is shown. | ||
=== Firmware === | === Firmware === | ||
| Line 21: | Line 23: | ||
|- | |- | ||
| 222 || Include support for Active Directory | | 222 || Include support for Active Directory | ||
| + | |- | ||
| + | | b934646 || Add the ability to disconnect a door controller's session if it misses too many keepalives | ||
|} | |} | ||
Revision as of 17:51, 4 December 2015
The internal revision number increments every time a change to any component across all of esctl is made, therefore it is not a good indicator of what changes have been made (if any) since a previous revision number.
The following tables show key revisions and the changes each introduced.
Development has migrated from SVN to git. For earlier changes, the SVN revision number is given; for later changes only the git commit ID is shown.
Firmware
| Revision | Change |
| 175 | First general release |
| 197 | Internal voltage measurement |
| 221 | Consider the PC controller alive only if a command is sent |
Software
| Revision | Change |
| 175 | First general release |
| 222 | Include support for Active Directory |
| b934646 | Add the ability to disconnect a door controller's session if it misses too many keepalives |
Hardware is not tied to a software revision as such; however hardware versions (as seen in serial_numbers.txt) are as follows:
Hardware
| Version | Change |
| 1 | First general release |
| 1-noeth | Serial connectivity - no Ethernet |
| 1.1 | Lock power also fed from 2-pin Phoenix connector |
