Door Controller/Construction details
From ESCTL
< Door Controller(Difference between revisions)
(→Construction details) |
|||
| Line 4: | Line 4: | ||
* Suggested wiring order | * Suggested wiring order | ||
** 1 F-F 5V PSU -> Ethernet | ** 1 F-F 5V PSU -> Ethernet | ||
| − | ** | + | ** 5 M-F vIn/GND/Reader/Voltage_Divider -> Arduino |
** 3 M-F Arduino TX/RX, GND-> Ethernet | ** 3 M-F Arduino TX/RX, GND-> Ethernet | ||
** ''1 M-F Arduino CFG -> Ethernet'' | ** ''1 M-F Arduino CFG -> Ethernet'' | ||
Revision as of 21:01, 8 December 2014
Construction details
- Serial version: TX-TX, RX-RX from RS232 driver to Arduino
- Ethernet version: TX-RX, RX-TX from Ethernet driver to Arduino
- Suggested wiring order
- 1 F-F 5V PSU -> Ethernet
- 5 M-F vIn/GND/Reader/Voltage_Divider -> Arduino
- 3 M-F Arduino TX/RX, GND-> Ethernet
- 1 M-F Arduino CFG -> Ethernet
- 4 F-F Relay -> Arduino
Connection board
- Brown/Blue cable length: cut to 75mm
Bi-colour LED
- Black/Red/Green cable length: cut to 30cm
- For LED SC07647
- Resistor value 120R
- Pin by flat edge: Red
- Centre pin: Ground
- Pin opposite flat edge: Green
