Door Controller/Construction details
From ESCTL
< Door Controller(Difference between revisions)
(→Connection board) |
(→Connection board) |
||
| Line 10: | Line 10: | ||
== Connection board == | == Connection board == | ||
| + | Currently constructed from RS 433-832 stripboard, cut to 15x5 sections (was 12x5 before moving lock connector to board) | ||
* Brown/Blue cable length: cut to 75mm | * Brown/Blue cable length: cut to 75mm | ||
* Voltage sense resistors: 4k7 connected to GND, 15k connected to Vin. Common joined and connected to Arduino A3 | * Voltage sense resistors: 4k7 connected to GND, 15k connected to Vin. Common joined and connected to Arduino A3 | ||
Revision as of 13:14, 12 July 2015
Construction details
- Serial version: TX-TX, RX-RX from RS232 driver to Arduino
- Ethernet version: TX-RX, RX-TX from Ethernet driver to Arduino
- Suggested wiring order
- 1 F-F 5V PSU -> Ethernet
- 5 M-F vIn/GND/Reader/Voltage_Sense -> Arduino
- 3 M-F Arduino TX/RX, GND-> Ethernet
- 1 M-F Arduino CFG -> Ethernet
- 4 F-F Relay -> Arduino
Connection board
Currently constructed from RS 433-832 stripboard, cut to 15x5 sections (was 12x5 before moving lock connector to board)
- Brown/Blue cable length: cut to 75mm
- Voltage sense resistors: 4k7 connected to GND, 15k connected to Vin. Common joined and connected to Arduino A3
Bi-colour LED
- Black/Red/Green cable length: cut to 30cm
- For LED SC07647
- Resistor value 120R
- Pin by flat edge: Red
- Centre pin: Ground
- Pin opposite flat edge: Green
