Door Controller/Construction details
From ESCTL
< Door Controller(Difference between revisions)
(Created page with "Construction details * Serial version: TX-TX, RX-RX from RS232 driver to Arduino * Ethernet version: TX-RX, RX-TX from Ethernet driver to Arduino Connection board * Brown/Blu...") |
|||
| Line 2: | Line 2: | ||
* Serial version: TX-TX, RX-RX from RS232 driver to Arduino | * Serial version: TX-TX, RX-RX from RS232 driver to Arduino | ||
* Ethernet version: TX-RX, RX-TX from Ethernet driver to Arduino | * Ethernet version: TX-RX, RX-TX from Ethernet driver to Arduino | ||
| + | * Suggested wiring order | ||
| + | ** 1 F-F 5V PSU -> Ethernet | ||
| + | ** 4 M-F vIn/GND/Reader -> Arduino | ||
| + | ** 3 M-F Arduino TX/RX, CFG -> Ethernet | ||
| + | ** 4 F-F Relay -> Arduino | ||
Connection board | Connection board | ||
Revision as of 17:04, 7 December 2014
Construction details
- Serial version: TX-TX, RX-RX from RS232 driver to Arduino
- Ethernet version: TX-RX, RX-TX from Ethernet driver to Arduino
- Suggested wiring order
- 1 F-F 5V PSU -> Ethernet
- 4 M-F vIn/GND/Reader -> Arduino
- 3 M-F Arduino TX/RX, CFG -> Ethernet
- 4 F-F Relay -> Arduino
Connection board
- Brown/Blue cable length: cut to 75mm
Bi-colour LED
- Black/Red/Green cable length: cut to 30cm
- For LED SC07647
- Resistor value 120R
- Pin by flat edge: Red
- Centre pin: Ground
- Pin opposite flat edge: Green
